Model Three Wine Lover Set
Featuring a molded architecture in a neutral colorway and limited accessories, the Model Three is the perfect entry point to Coravin Wine Preservation Systems. This set includes the Coravin Aerator, for an elevated wine experience, ideal perfect for the aspiring enthusiast.
The Model Three Wine Preservation System is our entry level Wine Preservation System, featuring a moulded architecture in a neutral colorway.
If your Coravin Needle becomes clogged, use the Needle Clearing Tool to clear out any cork particles.
30 Day Risk-Free Trial
1 (1) Reviews
A New Way to Pour Wine
Align the SmartClamps™ over the neck of the bottle and push down firmly on the Handle in one fluid motion.
Tip & Pour
Tilt the bottle until the Spout is over the glass. Quickly press and release the Trigger to pour.
How to Pour with Coravin
Each Capsule will allow you to pour up to fifteen 5-ounce (150ml) glasses of wine.
Average Pour Rate
On average, a 5-ounce (150ml) pour of wine with a Standard Needle will take 25 to 29 seconds.
The Needle in the Coravin System is intentionally off-center, so the Needle will insert into the cork in a different place every time.
- Model Three Wine Preservation System
- Injection Molded Plastic, Stainless Steel, Elastomers
- Coravin Pure™ Capsules
- Recyclable steel, 100% pure argon gas, Synthetic rubber, Fiberglass-reinforced nylon
- Stainless Steel, Injection Molded Plastic, Silicone
- Standard Screw Caps
- Injection Molded Plastic, Silicone, Polyethylene
- Needle Clearing Tool
How does a Coravin Wine Preservation System work?
The Coravin Wine Preservation System is easy to use - just insert, tip, and pour. Place the Coravin Wine Preservation System on top of the bottle and push the Needle through the cork. Coravin works on all cork-sealed, still wines. Tip the bottle as if you are pouring from an open bottle. For our traditional systems, quickly press the trigger to pressurize the bottle. Release the trigger to pour into your glass. For the Model Eleven just tilt and pour. Tip the bottle back up to stop the pour. Remove the Needle by pulling the system straight up. The cork will reseal naturally and continue to protect your wine for weeks, months, or even years.
How do I change a Needle?
For Model One, Model Two, Model Two Elite, and Limited Edition please click here.
For Model Three, Model Five, and Model Six please click here.
For Model Eleven, please click here.
My Coravin System does not seem to hold gas very long. What should I do?
Please ensure that you are tightening the Capsule Cup as quickly and firmly onto the System as possible; there should be no more give left to the cup. If the cup is not twisted on tightly enough, it may not seal fully, allowing argon gas to escape from the Coravin System.
Also, be sure that you use only enough gas for the pour that you want. If, when you finish your pour and bring the bottle back to an upright position, you hear a long release of gas then you may have used too much gas for the pour that you want; the gas just releases into the air and is wasted. At the end of your pour you should hear only a slight “psst” of gas if you hear anything at all. We recommend using several short presses of the trigger to control your pour and optimize your gas.